2026-11-08 · 2 min read

Eight new guides went up on /resources this week. Each one answers a question that came in often enough to be worth writing down.

The eight

  • Electrode diameter: what 2.5, 3.2 and 4.0 mm actually change. Plate thickness and position pick the size, not preference.
  • Base metal to filler metal: a matching table. Twelve rows — base metals, one dissimilar pair, one surfacing case — and the pairs people get wrong.
  • AWS A5.1, A5.5, A5.4 and A5.9: which standard covers what, and how the prefix of a designation tells you which one applies.
  • E7018 vs E7016 vs E7015. All three are 70 ksi and low hydrogen. The fourth digit is the difference, and it decides whether your machine can run the electrode at all.
  • E308-16 vs E308L-16. What the L changes, and when it changes nothing worth paying for.
  • Aluminium: E4043 or brazing wire, and what 419 and 505 degrees decide.
  • FCAW vs GMAW. What the flux core buys you and what it costs you in slag.
  • MIG wire diameter: 0.8, 1.0 or 1.2 mm.

Two of them have no numbers on purpose

The electrode diameter guide has no amperage column. Neither does the MIG wire one.

That was deliberate. The current range belongs to the coating and the shielding gas, not to the diameter. Print one number against 3.2 mm and it is wrong for the next grade somebody picks up. Ask for the datasheet and you get the range for the electrode you are actually buying.

Where they sit

All eight are under /resources. Every grade page now links to whichever guide covers it, so you can start at a product and end up at the comparison.

Fifteen guides in total now. If there is a question you keep having to answer for us, send it.