2026-11-04 · 5 min read
Aluminium gets joined by two routes, and the consumable tells you which one you are on. A covered electrode fuses the base metal. A flux-cored brazing wire does not — it melts and wets, while the aluminium stays solid. Both produce a joint. They fail differently, they are inspected differently, and they suit different jobs.
The two routes
| E4043 | Aluminium brazing wire | |
|---|---|---|
| Classification | AWS A5.3 | Not classified under A5.3 |
| What happens | Base metal melts and mixes with the filler | Filler melts; base metal stays solid |
| Current | AC or DC | Not an arc process in the same sense |
| Flux | In the electrode coating | Carried inside the wire, 50% by weight |
| Where it fits | Aluminium structures and castings where the joint is a weld | Sheet, thin sections, and joints where melting the base metal is the risk |
The distinction that matters commercially is the second row. On thin aluminium sheet, a fusion weld puts the base metal close to its melting point and the heat travels. Brazing keeps the base metal below that, so distortion and burn-through are much less of a fight. On a structural aluminium joint that has to carry load, brazing is not the answer and E4043 is.
What 419 and 505 decide
We supply two aluminium brazing wires, and the number in the name is the working temperature in degrees Celsius. That single figure decides which one flows on a given job.
| Wire | Working temperature | Sizes | Choose it when |
|---|---|---|---|
| Al-braze 419 | ≈ 419 °C | 1.6, 2.0, 2.4 mm | The alloy or the joint fit needs the lower temperature, and the base metal must not be brought near its own melting point |
| Al-braze 505 | ≈ 505 °C | 1.6, 2.0 mm | The lower-temperature wire will not flow into the fit, or the alloy needs more heat to wet properly |
The rule is to use the lowest working temperature that will actually flow on the joint. A higher temperature is not a better joint; it is more heat into a base metal that did not want it. Start with the 419 °C wire and move up only if it will not wet.
Copper to aluminium is a third case
Copper and aluminium cannot be fusion welded to each other. At welding temperature they form brittle intermetallic compounds at the interface, and the joint cracks — sometimes immediately, sometimes in service. The answer is a brazing wire formulated for that specific dissimilar pair, which is what our Cu-Al flux-cored brazing wire is for. It is supplied in 1.6 mm and 2.0 mm with the same 50% flux core as the aluminium grades.
Two practical notes
- The flux is inside the wire at 50% by weight, so no separate flux is applied. That also means the residue has to be dealt with after the joint — brazing flux left on aluminium keeps working on the surface.
- Aluminium conducts heat away fast, and the oxide layer on the surface melts at a far higher temperature than the metal underneath. Both are reasons aluminium brazing rewards a slower, more even heat than steel work.
If you are not sure which route a joint needs, send the alloy, the section thickness and whether the part carries load. Whether the base metal may melt is the question that decides everything else.