2026-10-20 · 6 min read

WT20 and WC20 are the two tungsten electrodes we supply, and they are the pair buyers most often ask us to compare. Both are 2% oxide-doped tungsten. The difference that matters is not the arc — it is what the oxide is, and what that means for how the electrode has to be stored, ground and disposed of.

Two designation systems, one electrode

Tungsten electrodes carry two parallel designations, and it is worth knowing both because a purchase order may quote either. AWS A5.12 uses the EW series; ISO 6848 uses the W series, and the AWS classification is based on the ISO one. So WT20 on a box is the same electrode as EWTh-2 on a certificate, and WC20 is the same electrode as EWCe-2.

WT20WC20
AWS A5.12EWTh-2EWCe-2
ISO 6848WT20WC20
Nominal addition2% thoriated2% ceriated
Principal oxide1.7–2.2% thorium oxide1.8–2.2% cerium oxide
Colour codeRedGrey (formerly orange)
RadioactiveYesNo
Power sourceDC, transformer-based constant currentAC or DC, inverter or transformer

The radioactive difference is a handling issue, not a sales point

Thorium oxide is radioactive, and that is a property of the material rather than a matter of degree in normal use. It means a thoriated electrode carries requirements around storage, grinding dust, welding fume and scrap disposal. We are not going to tell you that one electrode is safe and the other is not — that judgement belongs to your own safety and environmental requirements and to the regulations where you operate. What we can tell you factually is that WT20 contains thorium oxide and WC20 does not, and that this is the usual reason a workshop moves its standard electrode to the ceriated grade.

The power source narrows the choice more than the colour does

WT20 is at its best on direct current with a transformer-based constant-current source. It gives good DC arc starts and stability, with a medium erosion rate and a medium amperage range.

WC20 runs on alternating or direct current, on inverter or transformer equipment. It is characterised by good ignition and re-ignition, a long service life, low erosion and no spitting, and it is strongest in the low-amperage range — which is where a lot of thin-section and precision TIG work actually lives.

Reading the colour code correctly

A red tip identifies the thoriated grade and a grey tip the ceriated one, and the colour is applied to one end of the electrode for exactly that reason. Treat the colour as a quick check, not as proof: electrodes get mixed in a drawer, and a dipped or re-ground end loses its marking. For anything where the grade matters, go by the box label and the certificate rather than by the tip.

Choosing between them

  • Direct current on transformer equipment, welding non-corroding steels, titanium, nickel or copper alloys: WT20 is the conventional choice.
  • Alternating and direct current on the same machine, or inverter equipment: WC20 covers both without changing electrode.
  • Work that spends most of its time at low amperage, or where re-ignition quality matters: WC20 is the stronger of the two.
  • A workshop with requirements around radioactive material in the consumable store: WC20 contains no thorium.
  • Aluminium and magnesium on alternating current: WC20 covers both, though the ceriated grade is not the only route and the oxide choice should follow your procedure.

What we supply

Both grades are packed 10 pieces to a plastic box. The recorded order quantities are 50 pieces on WC20 and 200 pieces on WT20. Diameters and lengths are confirmed on the order rather than assumed from a stock list, so state what your torch takes.

This article is a selection guide only. Electrode grade, current and preparation should follow your welding procedure and the standard in force — AWS A5.12 or ISO 6848 as applicable — and the manufacturer technical file governs.